2. Safety instructions
2.1 Introduction
The UPS is a device that has been produced according to the rules and regula-
tions of technology for an uninterruptible power supply.
The device is safe when used properly and in compliance with the safety re-
quirements and instructions provided in this operating manual.
2.2 Proper use
The UPS and its related components may only be used for purposes according
to its design – for the supply of electrical devices from a primary power source
and for the short-term supply for loads from a secondary power source without
exceeding the nominal power in its entirety. Any other use above and beyond
this is considered improper and can lead to injury of person or property and/or
damage to the device!
The device is not designed for use:
– in explosive,
– in dusty or humid,
– in radioactive or,
– in biologically or chemically contaminated atmospheres!
For information about the respective IP protection class of the device, please
contact our service centers.
In addition, the device class must be noted with regard to the operating principle
of the UPS. For this, see the standard DIN EN 62040-3 (UPS Classifications).
Class VI devices are not designed to support sensitive devices because, for ex-
ample, the configurations of the switchover times could cause malfunctions. The
same applies to the use of medical devices as loads.
Please always note the information about the UPS class in the specifications
provided (13 Technical data) with respect to its use.
To Next Page
