6.1.1 Standby mode (STANDBY) of the UPS
✓ The device is switched off and not yet connected to the supply net-
work.
If the UPS is coupled with the supply net-
work (UPS input), the UPS initializes and
switches directly to the standby mode. The
battery bank of the device is already
charged by this time.
The display pictured here appears and
directly indicates the input voltage (mains
voltage). The UPS output has not yet been
switched on. The symbol for charging
activity appears.
A short acoustic signal is emitted during the
initialization of the device.
6.1.2 Starting or switching the UPS on in standard operating mode / charging
mode
✓ The device is in STANDBY status (6.1.1).
Once the ON button has been activated for
more than 3 seconds, the device automati-
cally starts up.
The device starts up and automatically
switches to the standard operating mode
or the charging mode. In the meantime,
the information is ON in the lower right-
hand corner.
The operating parameters can be viewed
with the SELECT button.
A short acoustic signal occurs in this start-
up process.
To Next Page
Loading...
