EFILive AutoCal V3 - Page 27

AutoCal V3 User Guide
support@efilive.com - 25 - www.efilive.com
Set WO2 Type
Select the type of Wide Band device connected to
serial port*.
Set WO2-1 ID
Configure the ID's for multiple ECM AFR wide
band controllers.
Set WO2-2 ID
Configure the ID's for multiple ECM AFR wide
band controllers.
Set Stoich
Set the stoichiometric value for the fuel that is
being used.
For Innovate’s wide band controllers, the stoich
value can’t be set using this option, instead it
must be set using Innovate’s Logworks software.
Log Serial PIDs
Log external digital (ie. Wide Band Serial) PIDs.
Load MRU PIDs
Not yet available.
12V Switch Log
Connect 12V to start logging. Disconnect 12V to
stop logging. Set to Yes or No.
12V Switch Beep
Only active when 12V Switch Log is active.
Two short beeps indicate start, one long beep
indicates stop. Set to Yes or No.
Verify BBR
Perform extended verification of uploaded file.
Set to Yes or No.
Check BBX Space
Check available BBX space before copying files.
Set to Yes or No.
Save Trace Files
Automatically save trace file for read/flash errors.
Set to Yes or No.
GM Fast
Use EFILive’s Fast CAN mode which can make
CAN flashing twice as fast. Set to Yes or No.
Cummins BBF
Set Cummins flash speed as Unlimited, Fast, or
Standard.