Eighteeth E-connect S - Page 29

Page 29 / 59
300 r pm
CW
Ncm
2.5
2
1 3
OneShape
OneFlare
2Shape
OneCurve
4
If you selecting “OneCurve” (○,
1
), the
operation mode (○,
2
), speed (○,
3
) and torque
limit (○,
4
) will change according to the file
system default setting.
NOTE
Protaper
○,
R
, GATES
○,
R
, Pro.Glider
○,
R
, and
Wave one
○,
R
is a registered trademark of
Dentsply.
Mtwo
○,
R
, Flex.Master
○,
R
, Reciproc
○,
R
and R-
Pilot
○,
R
is a registered trademark of VDW.
K3XF
○,
R
, TF
○,
R
is a registered trademark of
SybronEndo.
OneG
○,
R
, OneShape
○,
R
, OneFlare
○,
R
,
2Shape
○,
R
and OneCurve
○,
R
is a registered
trademark of Micro-Mega
XPendo.Shaper
○,
R
, XPendo.Finisher
○,
R
,
iRace
○,
R
, BT-Race
○,
R
and BioRace
○,
R
is a
registered trademark of FKG
OneCurve
300 rpm
Fwd
Ncm
2.5
1
3 4
2
And the memory mode (○,
1
) will change
according, also operation mode (○,
2
), speed
(○,
3
) and torque limit (○,
4
) will charge
according to the file system default setting.
NOTE
All of memory mode (from M1-M10) can be
replaced with same mothed.
OneCurve
350
rpm
Fwd
Ncm
3.0
1
2
The parameters of “OneCurve” can also be
changed make it different from default setting,
and there will be 4 corners around the
parameter (○,
1
)(○,
2
).
If want to change back to default setting, long
press S to entry preset program during
standby state, select “OneCurve” and press