● to confirm, the default setting will be
recalled, and the 4 corners around will
disappear.
If want to change back to M1 (or M2-M10),
long press S to entry preset program during
standby state, press < or > to select M1
(or M2-M10) again, then press ● to confirm
Changing the default setting is not
recommended only if you are very sure it can
be changed, otherwise has risk of file broken.
During power off state, holding down press S then
press ● to entry advanced setting, the version
number software will appear on the display screen.
E-connect S can update software very easy without
tools and software. Contact your distributor to update if
necessary.
After updating, all of the setting parameters will be
covered.
Press S again, the “Auto Power Off” time can be
change, press < or > to adjust, then press ●
to confirm.
The “Auto Power Off” time can be set from 3-15
minutes.
To Next Page