16
If the cable housing can be pushed into the frame in any way during the check, it has been detached from the cable
housing counterpart at the Postpin mounting interface. Take out the seatpost and attach the outer sleeve in the coun-
ter part of the mounting interface
Pull the cable clamp of the
remote lever over the cable
and guide it all the way to
the cable housing.
Very slightly tighten its
screw with a 3mm Allen key
on both sides so it can still.
be moved. Position it about
2mm away from the cable
housing.
Check the measurement
again by pulling the cable
very lightly to ensure that
the cable has not slipped
back into the cable housing.
Otherwise adjust the cable
clamp until the distance of
2mm is correct again.
Cut the cable directly at the
cable clamp. Pull it away
from the cable housing a
little bit in order to have
the end of the cable itself
disappear within it.
To Next Page
Loading...