27
Chapter 5 Troubleshooting
5-3. Imaging Problems (for analog only)
Problem Possible cause and remedy
1. Display position is incorrect. • Use "Menu Position" in the Setting menu to correct the image
position (see “Hor. Position” (page 20)).
• If the problem persists, use the graphics board’s utility if
available to change the display position.
2. Vertical bars appear on the screen or
a part of the image is ickering.
• Use "Clock" in the Setting menu to adjust it (see “Clock” (page
20)).
3. Whole screen is ickering or blurring.
• Use "Phase" in the Setting menu to adjust it (see “Phase” (page
20)).
5-4. Imaging Problems (for digital only)
Problem Possible cause and remedy
1. (During DisplayPort signal input)
Turning the power o/on or exiting
power saving mode will move the
windows and icons. In a multi-
monitor environment, switching o
the power of one monitor will switch
the screen settings to a single-
monitor display.
• In the following step, set the “DP Power Save” function to “O”.
Setting the function to “O” may increase power consumption.
1. Press
to turn o the monitor.
2. Hold down
while pressing to turn on the monitor.
The function will switch between “O” and “On” each time the
operation is executed.
The current setting status can be identied based on the color
used to display the input port or signal error.
Setting Input port Signal Error
On
(default setting)
O
To Next Page
Loading...
Need help?
General