9
Chapter 1 Introduction
1-3. Attaching the Touch Pen Holder
Note
• The touch pen holder is supplied with the touch pen (Accessories (“Accessories” (page 36))).
Attach the touch pen holder to any one of the right-hand and left-hand holes in the rear of the monitor. To
x the touch pen holder, use the screw supplied with the touch pen.
1-4. EIZO LCD Utility Disk
An "EIZO LCD Utility Disk" (CD-ROM) is supplied with this product. The following table shows the disk
contents and the overview of the software programs.
●
Disk Contents and Software Overview
The disk includes adjustment software, touch panel software, and User’s Manual. For software
startup procedures or le access procedures, see the Readme.txt le on the disk.
Item Overview
Touch panel driver Touch panel driver supplied by EIZO.
*
1
TPOset Software for calibrating the sensitivity of the touch panel.
*
1
Use this software when touch operations are not registered or only registered
after pressing hard.
User’s Manual of this monitor (PDF le)
Outline dimensions
Readme.txt le
*1 Only for Windows. Refer to the corresponding User’s Manual on the CD-ROM for details on installation
and use.
To Next Page
Loading...
Need help?
General