3
GENERAL INFORMATION
It is essential for this instruction manual to be stored together with the appliance for future referencing; in
the event of misplacing it, a copy must be obtained directly from the manufacturer.
This information has been prepared for your safety and that of others.
Therefore, we kindly ask you to read it carefully before installing and using the appliance.
If upon reception of the goods the packaging should not be intact or should it be damaged, affix the
following wording: “GOODS SUBJECT TO CHECK”, with the specification of the damage and
countersigned by the driver; file a written complaint with the vendor within 4 calendar days (not business
days) from the date of delivery, after which no complaints shall be accepted.
For periodic maintenance checks and repairs, contact your nearest Technical Support Centre and only use
original spare parts. Failure to comply with this provision shall forfeit the warranty right
The “technical data” plate is located on the side panel of the appliance.
A periodic check (at least once a year) of the appliance contributes to extending its service life and assures
proper operation.
Any maintenance operation on the appliance must only be done by highly qualified personnel trained in
the operations to be performed.
Before performing any maintenance on the appliance, the power supply must be disconnected (act on the
safety magnetic circuit breaker located upstream of the appliance) and let it cool down.
The components that might require maintenance are all accessible by removing the left side and back of
the appliance.
The inappropriate or incorrect use of the appliance shall invalidate any liability and warranty right by the
Manufacturer.
The temperature of the appliance's external surfaces may exceed 60°C, only touch control elements.
Burn hazard!
Pay attention to handling food containers during and after cooking: they might be very hot. Wear
appropriate protective thermal clothing to prevent burns.
During operation, with the door open, do not remove the fan cover; do not touch the moving fans and
resistors which are still hot.
The maximum working height, referred to the highest surface level, must be 160 centimetres from the
floor. After installing the appliance apply the suitable adhesive symbol (supplied) at a height of
160 centimetres.
To prevent boiling, do not use containers filled with liquids or food that liquefy with heat, in excessive
amounts that cannot be easily kept under control. For this reason, only use trays that let you see inside
the container. When extracting a tray containing hot liquid pay attention not to spill any liquid.
Before performing any cleaning on the appliance, disconnect the power supply (from the safety circuit
breaker) and water supply (close the water cock). Let it cool completely.
To Next Page
Loading...
