5.4.4 Structure of command sections ....................................................................... 25
5.5 HELP command ...................................................................................................... 26
5.6 Debugging commands ............................................................................................ 26
5.6.1 BA - Bus Administrator..................................................................................... 26
5.6.2 CHECK_LINE .................................................................................................. 27
5.6.3 CTRL (D).......................................................................................................... 27
5.6.4 GET_STAT - Get status................................................................................... 28
5.6.5 IN ..................................................................................................................... 30
5.6.6 MSGR - Message read (D) .............................................................................. 33
5.6.7 MSGS - Message send (D).............................................................................. 34
5.6.8 OUT - Output (D) ............................................................................................. 35
5.6.9 QUIT (D) .......................................................................................................... 35
5.6.10 REC - Reconfigure (D)................................................................................... 36
5.6.11 START (D) ..................................................................................................... 36
5.7 Memory commands ................................................................................................. 37
5.7.1 ADDR - Addressing mode................................................................................ 37
5.7.2 MEM - Memory switch ..................................................................................... 39
5.7.3 RM - Read Memory.......................................................................................... 39
5.7.4 RP - Read logical Port data ............................................................................. 40
5.7.5 SM - Set Memory (D) ...................................................................................... 41
5.7.6 SP - Set logical Port data (D).......................................................................... 41
5.7.7 TEST_EEPROM (D) ........................................................................................ 42
5.8 Software development commands .......................................................................... 43
5.8.1 AS - Active Slave ............................................................................................. 43
5.8.2 CS - Create Slave ............................................................................................ 44
5.8.3 MVB_MODE - MVB access mode selection (D) .............................................. 44
5.8.4 LOP - List of ports ............................................................................................ 45
5.8.5 LOS - List of Slaves ......................................................................................... 46
5.8.6 LPORT - Modify the logical port of an active slave .......................................... 46
5.8.7 RESET (D) ....................................................................................................... 47
5.8.8 VER.................................................................................................................. 47
Appendix A: Technical Specifications .......................................................................... 49
Appendix B: Diagrams .................................................................................................... 57
To Next Page
Loading...