37
Errors/warnings Description and potential causes Solution
Code check Brief code “reminder”
The “Code” symbol with a sensor
container and a question mark behind it
is displayed for three seconds when you
insert a sensor.
You need to confirm or change the code
after 25 tests.
Confirm the code if it remains the same.
Alternatively enter the code for the new
sensor container.
Time display Time displayed with black background
The date and time were not set when
the device was configured/reset.
Set the date and time.
Device fails
to turn on
Device fails to turn on
Device fails to turn on, either in
configuration and display mode or in
standby mode.
Change the batteries.
If the problem persists, please contact the
Lactate Scout 4 service team.
Measurement
mode cannot be
configured
No droplet symbol displayed
Device is not switched on as sensor not
inserted properly.
Insert sensor with the black contacts
facing up until it clearly locks in place
(see Item 2.1).
To Next Page
Loading...
Need help?
General
