GENERAL INFORMATION
NP-eVENT-16_10-2018 3
• The Installation, Operation and Maintenance Manual accurately describes
the design of the compressor and its compliance with safety and technical
standards. The manufacturer reserves all rights to its wiring diagrams,
procedures and names.
General safety warnings
The manufacturer developed and constructed the equipment so that damage
would not occur when the equipment is used for its intended purpose. The
manufacturer considers it its obligation to describe the following safety
measures in order to avoid further damages.
• Equipment operation must comply with all local codes and regulations. In
order to ensure safe work, the operator and user are responsible for
following all applicable regulations.
• Original packaging should be kept for the possible return of the unit. Only
original packaging ensures optimal protection of the equipment during
transport. If it is necessary to return the equipment during the warranty
period, the manufacturer is not liable for damages caused by incorrect
packaging.
• The user must immediately notify the supplier if any problem occurs
during the use of the equipment.
• This product is not intended for use in areas where there is a risk of an
explosion. Do not operate the compressor in the presence of flammable
anesthetics.
• Never feed oxygen or nitrous oxide into the compressor. Compressor
components are not approved for oxygen or nitrous oxide use.
• This device can be used only with ventilators equipped with a low
pressure alarm.
Electrical system safety warnings
• The equipment must only be connected to an appropriate power source
that has correct grounding. In order to assure proper grounding, connect
the compressor to a receptacle marked "hospital grade".
• Before the compressor is plugged in, make sure that the voltage and
frequency of the mains specified on the equipment are the same as the
power mains.
• Before operating, check for possible damage to the equipment and any
connections. Damaged pneumatic and electrical lines must be replaced
immediately.
• If a technical failure occurs, immediately disconnect the equipment from
the mains (pull out the main power plug).
• During repairs and maintenance, ensure that:
- The main power plug is removed from the power socket,
- Compressed air lines are disconnected,
To Next Page
Loading...
