7
3.3 THE KEYPAD
ELCOMETER 207
Key Functions For more information see
Press to switch the gauge on or off.
When switching off, the gauge retains all of its settings.
If the gauge is idle for 5 minutes, it will switch itself off.
Press to switch SCAN mode on or off. “Scan mode” on page 20.
Press to adjust calibration. “Calibration” on page 15.
Press to change units (metric/imperial)
a) Increases values on the display (press and hold to change values quickly).
b) Switches between measurement modes (echo-echo, interface-echo or
auto).
a) Decreases values on the display (press and hold to change values
quickly).
b) Switches the display backlight between three settings; on, off and auto. “Backlight” on page 24.
c) Press and hold during gauge switch on to toggle LOC mode on/off
“Measurement mode” on
page 18
To Next Page
Loading...
Need help?
General
