P/N 0013-1025-001 Rev F
© 1998 Rockwell International Corporation. All rights reserved.
Printed in the United States of America.
Information contained in this manual is subject to change without notice.
Electro-Craft is a trademark of Rockwell Automation.
UL and cUL are registered trademarks of Underwriters Laboratories.
Other trademarks cited are the property of their respective owner.
Intro
!
WARNING
Only qualified electrical personnel familiar with the construction and operation
of this equipment and the hazards involved should install, adjust, operate or
service this equipment. Read and understand this manual and other applicable
manuals in their entirety before proceeding. Failure to observe this precaution
could result in severe bodily injury or loss of life.
Intro
!
WARNING
The user must provide an external, hardwired emergency stop circuit outside
the controller circuitry. This circuit must disable the system in case of improper
operation. Uncontrolled machine operation may result if this procedure is not
followed. Failure to observe this precaution could result in severe bodily injury.
To Next Page
Loading...