10
CYCLE, SYSTEMS & COMPONENTS
DISHWASHER CONTROL (CONT.)
Rinse Hold
This cycle is intended for dishes that are to be washed later. It is a rinse-only
cycle; options and soil sensing are not available.
TESTS FOR THE CONTROL
Water/Service Test
The service test will check the electronic control’s ability to ran all functions of the
dishwasher. This test may be entered from an idle mode or the power failure
mode, however different pads are used to activate.
Entering the Water/Service Test
From Power Failure
While the control displays power failure or flashing lights, press and hold the Short
wash and the Rinse & Hold pads simultaneously for one second. The dishwasher
will start through the test cycle.
From Idle
With no cycle selected and the dishwasher sitting idle, press and hold the Hi-temp
and the Start pads simultaneously for one second. The dishwasher will start
through the test cycle.
The chart on the next page shows the complete Water/Service Test cycle. To
manually move to the next phase of the cycle press the Start pad. If at any time the
door is opened the test cycle will end and flashing lights will come on showing
power failure. The Sanitize LED will light at the end of test to check the LED. If the
rinse aid dispenser is empty, the display will read LO to indicate the contact in the
dispenser is closed.
To Next Page
Loading...
