32
Mount on back of the sump
Push up on lock to release drain
pump from mount
Figure 46
Lock
tab
Check
valve
Figure 47
SERVICE & DISASSEMBLY
DRAIN PUMP (CONT.)
WASH MOTOR (SEE FIGURE 45)
1. Disconnect dishwasher from power and water supplies. Remove
drain line.
2. Remove dishwasher from countertop.
3. Lay dishwasher on its back on a protective pad.
4. Slide hose clamps on the “Y” hose toward heater. Leave intake
hose attached to motor.
5. To release motor mount (both front and rear), use blade of a small
screwdriver to pry between motor mount and motor mounting
bracket. (See Figures 48 and 49)
6. To remove wire plug, place blade of a small screwdriver between
disconnect and motor terminal block to release lock. (See Figure 50
for location of lock.)
7. Remove two wires connecting motor capacitor.
8. Remove hose from motor intake.
9. Reinstall in reverse order. Apply lubricant to hose clamps for easier
installation.
Figure 48
Front Mount
Figure 49
Rear Mount
To Next Page
Loading...
