7
3. Warnings
• Any work on Electrical Appliances must be carried out by a qualified professional.
• Confirm that the Power System is operational before working on the Appliance.
• Ensure that the gas pipelines are connected properly as mentioned in the Installation section for Gas Dryer
Models.
• Check that the Appliance is restored to its original safety condition after the operation is complete.
• Take the plug out of the socket to disconnect the power supply before you access
internal components. This platform is not fitted with an ON / OFF switch.
• Replace the heating element with the one that has the same characteristics to
maintain safety measures for the Appliance (See Figure).
• Always empty the Appliance before laying it on its side for any servicing.
• Always wear gloves before servicing any components.
• The resistance values of the components shown in this Service Manual (SM) are purely indicative and
approximate.
• The Sensors located on the Display Board could be at a potential of 220 Volts (If applicable).
• Do not place any container under the Appliance to avoid collecting drops of water.
WARNING
Certain internal parts are intentionally not grounded and may present a risk of electric shock only during
servicing. Do Not Contact any part while the Appliance is energized. For example, Water Valve.
Heating Element with
different Specification
To Next Page
Loading...
