Electrolux T5350 - Page 32

32
Service Manual
Demount the fan motor and remove the belt. Put the new belt in position and remount the motor.
Before remounting the motor it is important to lubricate the motor shaft with an anti-fretting paste (Antifret LAGF 3 /
0.6 or similar quality). Thighten the screws with tightening torque 20 Nm.
fig.7887
Remount the fan wheel on the fan motor. Lubricate the screw using a protection product such as Omnifit Seal 40M or
similar and tighten the screw with tightening torque 5 Nm.
Remount the fan module in the machine.
Fasten the belts and make sure the belts are in position. Fasten the belt tensioner and connect the motor cable.
Remount the rear panel.