Software Installation and Setup
Wait After Cure: The time difference between the end of the exposure and the start of the build platform to
leave the exposure surface, the default setting is 0 seconds.
Wait Before Cure: After the build platform moves to the printing surface, the time difference between the build
platform starting to stationary and starting to exposure, the default setting is 0.5 seconds.
Wait After Lift: After the printing platform is lifted, the time difference between the printing platform starts to
stationary and starts to return, the default setting is 0 seconds.
Bottom Wait After Cure: When printing the bottom layer, the time difference between the end of the exposure
and the start of the printing platform away from the exposure surface, the default is 0 seconds.
Bottom Wait Before Cure: When printing the bottom layer, the time difference between the printing platform
starting to stationary after moving to the printing surface and starting to exposure, the default is 0.5 seconds.
Bottom Wait After Lift: When printing the bottom layer, the time difference between the printing platform
starting to stationary after lifting and starting to return, the default is 0 seconds.
Bottom Lift Distance: During the bottom printing process, the distance that the build platform leaves the
printing surface each time, the default setting is 2+3mm.
Lifting Distance: In the normal layer printing process, the distance that the build platform leaves the printing
surface each time, the default setting is 2+3mm.
Bottom Retract Distance: During the bottom printing process, the retract distance of the build platform, please
do not change if not necessary.
Retract Distance: In the normal layer printing process, the retract distance of the build platform, please do not
change if not necessary.
Bottom Lift Speed: During the bottom printing process, the moving speed of the build platform away from the
printing surface each time, the default setting is 75+230mm/min.
Lifting Speed: In the normal layer printing process, the moving speed of the build platform away from the
printing surface each time; the default setting is 75+230mm/min.
Bottom Retract Speed: During the bottom printing process, the moving speed of the build platform is close to
the printing surface; the default setting is 230+75mm/min.
Retract Speed: In the normal layer printing, the moving speed of the build platform is close to the printing
surface; the default setting is 230+75mm/min.
Parameter mode: Default static mode. The printer will print according to the parameters set in the slicing
software. You can also choose high-speed mode or smooth mode. The printer will dynamically adjust the
printing parameters according to the complexity of the model to improve print quality and print speed.
Note: The printing parameters listed in this manual are for reference only. In actual applications, please contact
the official after-sales technical support to confirm the parameters based on comprehensive factors such as
the machine model and resin (including type and color) used by the individual.
14
To Next Page
Loading...
