Software Installation and Setup
(Picture7)
3.3 Resin Parameter (See Picture 7)
Resin Density: 1.1g/ml
Resin Cost: You can input the real price of the resin you purchased, and the slicing software can calculate the
resin costs for each model you print.
13
3.4 Parameters (See Picture 7)
Layer Height: The thickness of each printed layer, the recommended height is 0.05mm, but you can set it from
0.01-0.2mm. The higher the thickness you set, the longer the exposure time will be required for each layer.
Bottom Layer Count: The setting number of initial printing layers. If the number of bottom layers is n, the
exposure time of the first n layers is the exposure time of the bottom layer. The default setting is 2 layers.
Exposure Time: The exposure time for normal printing layers. The default exposure time is 2.5 seconds, and
the thicker the printing layer setting is, the longer the time it will take.
Transition Layer Count: The number of transition layers after the bottom layers for a tighter bonding between
layers. Except for the exposure time, other parameters of the transition layers are the same as the normal layers.
Bottom Exposure Time: The setting of bottom layer exposure time. Properly increasing the bottom exposure
time can help to increase the stickiness between the printed model and the printing platform, and the default
setting is 32 seconds.
To Next Page
Loading...
