Elenco Electronics Snap Circuits - Flashing H & O; Flashing C & E; Flashing F & H; Flashing P & S

-46-
Project #440
OBJECTIVE: Use the Alarm IC as a switch to flash the letters
“C & E”.
Use the circuit in project 435. Connect A, D, E, & F to the circuit. Turn
on the switch (S1) and the capital letter “C” should be flashing. Now,
connect A, D, E, F, & G to flash the capital letter “E”.
Flashing “C & E”
Project #441
OBJECTIVE: Use the Alarm IC as a switch to flash
the letters “F & H”.
Flashing “F & H”
Project #442 Project #443
Project #444 Project #445 Project #446
Use the circuit in project 440. Connect A, E, F, &
G to the circuit. Turn on the switch (S1) and the
capital letter “F” should be flashing. Now, connect
B, C, E, F & G to flash the capital letter “H”.
OBJECTIVE: Use the Alarm IC as a switch to flash
the letters “P & S”.
Flashing “P & S”
Use the circuit in project 440. Connect A, B, E, F,
& G to the circuit. Turn on the switch (S1) and the
capital letter “P” should be flashing. Now, connect
A, C, D, F, & G to flash the capital letter “S”.
OBJECTIVE: Use the Alarm IC as a switch to flash
the letters “U & L”.
Flashing “U & L”
Use the circuit in project 440. Connect B, C, D, E &
F to the circuit. Turn on the switch (S1) and the
capital letter “U” should be flashing. Now, connect
D, E, & F to flash the capital letter “L”.
OBJECTIVE: Use the Alarm IC as a switch to flash
the letters “b & c”.
Flashing “b & c”
Use the circuit in project 440. Connect C, D, E, F &
G to the circuit. Turn on the switch (S1) and the
letter “b” should be flashing. Now, connect A, F & G
to flash the letter “c”.
OBJECTIVE: Use the Alarm IC as a switch to flash
the letters “d & e”.
Flashing “d & e”
Use the circuit in project 440. Connect B, C, D, E,
& G to the circuit. Turn on the switch (S1) and the
letter “d” should be flashing. Now, connect A, B, D,
E, F & G to flash the letter “e”.
OBJECTIVE: Use the Alarm IC as a switch to flash
the letters “h & o”.
Flashing “h & o”
Use the circuit in project 440. Connect C, E, F, & G
to the circuit. Turn on the switch (S1) and the letter
“h” should be flashing. Now, connect C, D, E, & G to
flash the letter “o”.