48
SECTION 3: SWEAT INDUCTION AND COLLECTION
3.1 Preparing for Sweat Induction
7. Clean the Selected Skin Areas
Clean the skin at the selected location to remove dirt and loose dead
cells to minimize the electrical impedance of the skin. To do this:
a. Swab the area vigorously with alcohol, then rinse the area with a
generous amount of deionized water.
b. Leave the skin wet where the Pilogel disc is to be attached,
(Or)
Place a drop of deionized water on the skin or on the surface of
the Pilogel disc just before attachment. This ensures uniform
contact over the area and reduces the possibility of a burn.
c. Tap to advance to the next screen, or tap to go back to the
previous screen.
WARNING!
Follow the precautions found in Section 1.5.
To Next Page
Loading...
Need help?
General