ELNA 3210 - Rolled Hem

60
2
1
2
1
Rolled Hem
An easy professional way to sew hems. The spiral on the
hemmer foot guides the fabric edge to create a rolled
hem. Recommended for fine, sheer fabrics used in bridal
wear.
Trim 6.5 mm (1/4”) by 8 mm (3/8”) from corners to reduce
bulk.
Make a double 3 mm (1/8”) fold approximately 8 cm (3”)
in length.
Align fabric hem edge with the inside of right extension of
foot . Use this placement on foot as guide. Lower
presser foot. Sew 3 or 4 stitches while holding needle
and bobbin threads. Stop machine.
Lower needle into fabric and raise presser foot. Insert
folded portion of fabric into spiral of foot .
Lower presser foot and sew; lift up edge of fabric to keep
it feeding smoothly.
NOTE: Use zigzag with stitch width 1.0 – 2.0 for a
variation.
0
1.5 - 4
3 - 5
1