Fig5-17AlarmConguration-Sensor-AlarmHandling
6- Gotoalarmtabtoselecttheoptionstohandlealarm.
Fig5-18AlarmHandling-Trigger
Buzzer:Ifselected,thelocalbuzzerwouldbeactivatedonanalarm.
Show Full Screen: If selected, there will pop up the chosen channel on the monitor on an alarm trigger.
To Alarm Out: If selected, this would trigger external relay output on an alarm.
Email:Ifselected,theNVRwillsendanemailalerttothepreconguredemailaddressincaseofasensorbasedalarmfromtheparticularinput.
Snap: If selected, the system will snap images of the checked channels on an alarm and save them in the HDD automatically.
7-GotoToRecordtab.Selectrecordingchannels.Itwouldberecordedincaseofanalarm.ClickOKbuttontosavethesetting.
8-GotoScheduletab.Thesettingstepsforscheduleforsensorbasedalarmaresimilartonormalschedulesetup.Youcanreferto5.4.1Schedulefor
details.Thisstepisveryimportantforsensoralarm.Evenifyouhaveenabledthesensoralarmforallchannelsandsetthetrigger,youwillnotseethe
result of sensor alarm if no schedule is added.
Ifyouhavesetscheduleforsensorbasedrecordinginthesametimeline,recordingscanalsobetriggered.
5.5.2 Motion Alarm
Motionincludestwosubmenus:motionandschedule.Thestepstosetmotionalarmareasfollows:
1-GotoMainMenu
Setup Alarm Motion Motiontab.RefertoFig5-19.
2-Enablemotionalarm,setalarmholdtimewhichreferstothetimetillwhichthesystemwillwaitforfurtherdetectionofmotion.e.g.Iftheholdingtimeisset
to10seconds,oncethesystemdetectsamotion,itwillgotoalarmbutwouldnotdetectanyothermotionalarm(specictochannel)until10seconds.If
thereisothermotiondetectedduringthisperioditisconsidereditascontinuousmovement,otherwiseitwillbeconsideredasasinglemotion.
Fig5-19AlarmConguration-Motion
3 - The setup steps of motion trigger are similar to “Alarm Handling” (See Chapter 5.5.1 Sensor Alarm Handling setting for more details).
4-AfterclickingAreabutton,adialogboxwillpopupasFig5-20.
EN