59
Fig5-25NetworkConguration-Server
5.6.4 NAT
1-GotoMainMenu
Setup Network NAT interface. Refer to Fig 5-26.
2-EnableNATandinputtheNATServer(ThedefaultNATServeriswww.autonat.com).
3 - Click “Apply” to save the settings.
SMTPServer/Port:ThenameandportnumberofSMTPserver.YoucansetupSSLcheck(suchasGmail)accordingtoactualneeds.
5.6.3 Server
This function is mainly used for connecting ECMS/NVMS. The setting steps are as follows:
1-Intheserverinterface,select“Enable”asshownintheFig5-25.
2-ChecktheIPaddressandportofthetransfermediaserverintheECMS/NVMS.Thedefaultserverportforautoreportis2009.Ifitismodied,please
go to the transfer media interface to check.
3-EnabletheautoreportintheECMS/NVMSwhenaddinganewdevice.Thenself-denedeviceIDandinputtheremaininginformationofthedevicein
the ECMS/NVMS.
4-Inputtheabove-mentionedserverIP,serverportanddeviceIDintheserverinterface.Thenclick“Apply”buttontosavethesetting.Now,theECMS/
NVMS system will automatically connect this device.
Fig5-26NetworkConguration-NAT
5.6.5 Other Settings
IfyourNVRissettousePPPoEasitsdefaultnetworkconnection,youmaysetupDDNStobeusedinconnection.Thesettingstepsareasfollows:
1-EnableDDNSserver.
2 - Select DDNS server.
3-Enterusername,passwordandhostdomainnameoftheregisteredwebsite.
4-Click“Test”buttontotesttheeffectivenessoftherelevantinformation.
5-Click“Apply”buttontosavethesetting.
Fig5-27NetworkConguration-OtherSettings
Note:ThedomainnameselectedbyuserisabandingdomainnameofNVR.Usershouldlogonthewebsiteprovidedbytheserversuppliertoregisterauser
nameandpasswordandthenapplyforadomainnameonline.Afterthesuccessfulapplication,usercanaccessthedevicefromtheIEclientbyinputting
that domain name.
Enable UPnP:SelectUPnPhereandthenenableUPnPfunctioninyourrouter.Therefore,thereisnoneedforyoutoforwardLANIPaddressandportin
the router in connection of internet.
EN