48
Reference Manual
00809-0200-4420, Rev HC
Section 5: Operation and Maintenance
July 2015
Operation and Maintenance
To add a new data point to the Ethernet/IP register map:
1. Select New entry.
2. Complete all of the table entries for the new data point (note that the entry columns
may vary based on the Ethernet/IP communications settings).
3. Repeat for each new data point.
4. Select Submit.
5. When changes have been accepted, select Return to form.
See Table 5-1 on page 42 for options of parameters that can be mapped.
Terms Description
Delete Selected Removes the selected entry from this table
Select All Selects all table entries
Select None De-selects all table entries
Select Errors Selects all table entries that have an error message
Submit Accepts all changes (highlighted in yellow)
Table 5-4. Summary of Terms Used for the Ethernet/IP Mapping Page
To Next Page
Loading...
