Emerson Bettis SCE300 - Page 35

31
Installation and Maintenance Instructions
MAN-02-04-99-0712-EN Rev. 1
February 2020
Actuator Configuration
Section 6: Actuator Configuration
NOTICE
The actuator conguration does not need to be performed in the order as indicated by the
following steps. Each parameter can be set independently.
Conguration of the actuator parameters is conducted via the following components:
• Two rotary selector switches SW6 and SW4 for actuator conguration
• Enter pushbutton SW5 (conrmation pushbutton)
• Dip switch SW3 (enable conguration function)
• Green LED indicating power ON (switched on when power supply is available)
• Red LED for Enter conrmation (ON once conguration is conrmed)
• Mechanical stops
Figure 15 Configuration of the actuator parameters