54 100-412-196 REV. 06
2
Press the Mode/Configuration key once to get into mode
selection. Current selected mode icon will blink.
3
Use the Up/Down Arrow keys and the Left/Right Arrow keys
to select Energy Mode, then press the Enter key to confirm
the selection. You will be directed to the parameters area.
NOTICE
Only the weld control modes will be visible.
4
Energy icon and parameter numbers will flash. Use the Up/
Down Arrow keys and the Left/Right Arrow keys to enter the
desired value, then press the Enter key to confirm the
selected value.
NOTICE
Only the parameters associated with the selected mode will
be displayed.
NOTICE
Reference image showing default Energy setting of 1 Joule.
Table 6.5 Energy Mode Operational Sequence
Step Action Reference
To Next Page
Loading...
