WARNING!
CRUSHING HAZARD
Do not remove flange stabilizers.
Attempting to do so may allow the meter to roll, resulting in serious injury or equipment
damage.
A. Flange stabilizers
CAUTION!
ESCAPING GASES OR FLUIDS HAZARD
The purchaser of the meter is responsible for the selection of Daniel components/seals and materials
compatible with the chemical properties of gas flow measurement.
Failure to select the suitable meter component/seals may cause escaping gases or liquids,
resulting in injury or equipment damage.
1.2
Field hydrostatic pressure testing procedures
Daniel 3410 Series Ultrasonic Gas Flow Meters are supplied with T-Slot transducer
assemblies which are extractable while the line is pressurized.
CAUTION!
LEAKAGE OR PRESSURE CONTAINING PARTS FAILURE
Use precautions to eliminate hazards to personnel in the event of leakage or failure of the liquid
ultrasonic meter pressure containing parts or failure of the test equipment and to prevent over-
pressurization during the test procedure.
Failure to comply may result in injury to personnel or cause damage to the equipment.
Maintenance
2 Gas Ultrasonic Flow Meters
To Next Page
Loading...
Need help?
General
