Emerson Liebert APS - Figure 20 Install the Guide Rails; Figure 21 Install the Brackets

Installation
19 Liebert
®
APS
™
Figure 20 Install the guide rails
4. Unscrew the 10 screws on the front of the two side panels of the UPS frame.
5. Use those screws to attach the brackets to each side of the UPS frame, as shown in Figure 21.
Figure 21 Install the brackets
6. Push the Liebert APS frame slowly into the enclosure from the front, as shown in Figure 22. The
rear of the UPS goes into the rack first when installing through the front of the rack.
C
Guide
Rail
Mounting Slot
Insert one end
of the guide rail
into the mounting
slot on the tray
Detail C
D
Detail D
Screw
(8 places)
Bracket
Bracket