Emerson Liebert APS - Install System Control and System Monitor Modules; Figure 27 Lever and Fastener; Figure 28 Remove Large Plastic Bezel and User Interface Module

Installation
23 Liebert
®
APS
™
Figure 27 Lever and fastener
4. Replace the small plastic bezels.
2.4.2 Install System Control and System Monitor Modules
1. Remove the display bezel and the user interface (LCD) module on top of the frame, as shown in
Figure 28.
Figure 28 Remove large plastic bezel and user interface module
2. Push the module slowly until about 1cm of the module is still out of the bay, and then press it
firmly to ensure that the module is fully inserted, as shown in Figure 29.
NOTE
If the lever of the module cannot be pressed down smoothly, remove the module and reinstall it.
Pull Out
Press
Downward
After Pressing the Lever
Side View
Before Pressing the Lever
Side View
Locking
Lever
Display
Bezel
User
Interface
Module