Emerson Liebert APS - Figure 22 Push the UPS Frame into the Rack; Figure 23 Fix the UPS Frame

Installation
Liebert
®
APS
™
20
Figure 22 Push the UPS frame into the rack
7. Use eight panel screws to secure the UPS frame to the rack posts, as shown in Figure 23.
Figure 23 Fix the UPS frame
8. Use four screws to install the metal plate (accessory in the rack-mount kit) on the corresponding
position on the lower front part of the UPS frame
9. Insert the plastic bezel into the square holes of the metal plate, as shown in Figures 24 and 25.
NOTE
It might be necessary to use the leveling feet to get the holes to align
Guide Rails
Push the
UPS frame
into the
rack.
Front of Rack
Front of UPS
Panel Screw (8 Places)
Detail E
E