Emerson Liebert APS - Replacing the User Interface Module; Figure 73 Replacing the User Interface Module

Troubleshooting
Liebert
®
APS
™
66
5.3.2 Replacing the User Interface Module
1. Remove the display bezel on top of the frame.
2. Lift up the user interface module, and put it on top of the UPS frame.
3. Disconnect the network cable from the user interface module.
4. Connect the network cable to the new user interface module.
5. Insert the new user interface module into the clips and replace the display bezel.
Figure 73 Replacing the user interface module
Display Bezel
User Interface
Module