Emerson Liebert APS - Figure 68 Module Replacement Screen; Figure 69 Example of Prompt Window; Module Replacement Screen; Prompt Window

Operation and Display Panel
Liebert
®
APS
™
58
4.5.5 Module Replacement Screen
From the main screen, press the F4 button nine times until the module replacement screen is
displayed, as shown in Figure 68.
Figure 68 Module replacement screen
The module replacement screen displays the procedures for replacing all user replaceable module
assemblies in the UPS frame.
To view the procedure, press the F5 button to enter the module replacement. One module option is
highlighted. Press the F3 or F4 button to navigate to the specific module procedures, and then press
the F5 button to view the procedures. Once completed, press the F2 button to exit.
4.5.6 Prompt Window
During system operation, occasionally the UPS system needs to alert or remind the user of alarm
notifications or require the user to confirm a command or perform other operations. When this occurs,
a prompt window will pop up, as shown in Figure 69. Refer to Table 21 below for possible prompts
and the descriptions/actions to be taken.
Figure 69 Example of prompt window
Module Replacement Screen
LCD Board Replacement Procedures