Emerson Liebert APS - Figure 29 Insert the System Control and System Monitor Module; Figure 30 Lever and Fastener on System Control and System Monitor Module

Installation
Liebert
®
APS
™
24
Figure 29 Insert the System Control and System Monitor module
3. Use a #2 Phillips screwdriver to install the screws into the holes on each end.
4. Slide the lever toward the right, as shown in Figure 30.
Figure 30 Lever and fastener on System Control and System Monitor Module
5. Replace the LCD module and display bezel.
10mm
Insert
module
here
Mounting
Hole
Lever
Mounting
Hole
Pull
Out
Before Pressing
Lever
After Pressing
Lever
Press and Slide
to the Right