Safety
Information
Product
Information
Mechanical
Installation
Electrical
Installation
Getting
Started
Basic
parameters
Running the
Motor
Optimization
SMARTCARD
Operation
Onboard
PLC
Advanced
Parameters
Technical
Data
Diagnostics
UL
Information
Quantum MP User Guide 17
Issue: A4 www.emersonct.com
3.3.4 Installation and removal of a Keypad.
Figure 3-4 Removal and installation of a keypad - Size 1 shown
To fit the keypad in a Quantum MP size 1 or size 2, align the Keypad and
press gently in the direction shown until it clicks into position (A).
To remove, while pressing the tabs inwards (B), gently lift the keypad in
the direction indicated (C).
The keypad can be installed / removed while the drive is powered up and
running a motor, providing that the drive is not operating in keypad
mode.
To Next Page
Loading...
