Reference Manual
00809-0100-4716, Rev JA
May 2008
Rosemount 3095 MultiVariable
3-2
HART
ENGINEERING
ASSISTANT SOFTWARE
The 3095 Engineering Assistant (EA) Software is a PC-based software
package. The EA Software lets you configure the 3095 Multivariable Mass
Flow Transmitter and 3095 Multivariable Mass Flowmeters.
The EA Software is available as a Snap-On application to AMS 6.0 and
newer, or as Stand-Alone Software powered by AMS. The EA Software
performs configuration, maintenance, and diagnostics functions, and serves
as the primary communications interface to the 3095 transmitter and 3095
Mass Flowmeters.
Installation and Initial
Setup
The following are the minimum system requirements to install the 3095
Engineering Assistant Software:
• IBM-compatible PC
• Pentium 800 MHz personal computer or above
• Operating System: Microsoft
©
Windows
™
NT, 2000 or XP
• 512 MB RAM
• 350MB of available hard disk space
• CD-ROM
• 800 x 600 256 color display
NOTE
The available hard disk space specified above is the amount needed for
software installation, not the amount needed for operation (disk space needed
will vary from network to network depending on configuration, number of
devices, etc.).
Installing the 3095 MultiVariable Engineering Assistance Software
The EA Software package is available with or without the HART modem and
connecting cables. The complete EA package contains the EA software
CD-ROM, and one HART modem with cables for connecting the computer to
the 3095. Optional USB HART Modem and cables include separate software
to install USB HART modem drivers. Install USB HART Modem drivers
following the instructions provided with the modem. Install USB HART Modem
drivers prior to beginning the EA software installation.
1. For Stand-Alone users, install the 3095 Engineering Assistant
software by clicking on the “setup.exe” file located on the CD-ROM.
2. For Snap-On users, AMS is a two CD-ROM series with the 3095
Engineering Assistant on the second disk. After installing AMS, install
the 3095 Engineering Assistant software by clicking on the
“setup.exe” file located on the second CD-ROM.
3. A series of screens (called the “Installation Wizard”) will appear and
assist in the installation process. Follow the on-screen instructions. It
is recommended that the default settings on the PC are used.
4. The system will reboot. Installation will continue until the “Finished”
prompt appears.
NOTE
For AMS users, AMS must be installed and activated by submitting the proper
license codes before EA can be launched as a Snap-On option.
To Next Page