7. With one wrench holding the eductor elbow (N, Figure 10-10) and one
wrench on flats of sensor holder (J), unthread and remove the COe sensor
assembly (I).
Do not allow the eductor elbow to turn.
8. Slide the band heater (M) and heater insulator (K) from the sensor holder (J).
Remove eductor
Prerequisites
Remove the O
2
cell and heater strut assembly (Figure 10-8) and the COe assembly
(Figure 10-10) before you start this procedure.
Procedure
1. Use a straightedge to matchmark alignment of the eductor flat and elbow,
as shown in Figure 10-12.
Manual Maintenance and service
00809-0500-4880 December 2022
Rosemount OCX8800A 257
To Next Page
Loading...
