48
Con guring & Managing Accessories
Con guring a Wired Sensor
➤ Press the CONFIG button once. The screen will show CCC.
➤ Press the F|C button four (4) times or until you arrive at a screen that shows J0
➤ Press the UP button on the thermostat to make sure the screen reads J1
➤ Press the ON/OFF button to save the settings.
➤ Press the RESET button on the front of thermostat
The thermostat is now con gured for use with the Wired Auxiliary Occupancy sensor
for lighting applications.
*Indicates default setting.
Preset Connected Devices Preset
J-0* No device connected to the JKT port
J-1 Wired Occupancy Sensor connected to JKT port
J-2 Wired Door/Window Switch connected to JKT port
To Next Page
Loading...
