51
Troubleshooting
Pairing the thermostat
In the case of a networked installation with online management, the thermostat
must be paired with a Network Programmer specic to the property before the
installation.
The thermostat must not be powered during the pairing procedure.
➤ Plug the HDMI cable into the mini HDMI port on the thermostat;
➤ Press the black button on the programmer. The red light on the programmer
should turn on and remain steadily lit;
➤ If the red light on the programmer is blinking or is not steadily lit, unplug the
programmer from the thermostat and repeat the steps above.
➤ Unplug the programmer from the thermostat.
To Next Page
Loading...
