Emerson VERDANT VX Series - Restoring Factory Settings

52
Restoring Factory Settings
If there are reported errors or conguration issues, the user may restore factory
settings to return the thermostat to its default parameters.
Procedure
➤ Remove the faceplate of the thermostat;
➤ With the thermostat on, press the CONFIG button located on the control
board inside the thermostat.
➤ Press the F|C button twice, or until you reach the equipment code
conguration screen.
➤ Press and hold the CONFIG button. The screen wil display “RST”
➤ Press the F|C button.
If the master reset was successful, the thermostat will display “VRD” and then
“SETUP” on the screen. The thermostat must now be re-congured. Please refer to
pages thermostat conguration section of this manual.
Contact Verdant technical support if the issues are not resolved.
Troubleshooting