MAC Address: Type the MAC address of the user's network interface.
Add: Click to add the user to the list at the bottom of the page.
Update: Click to update information for the user, if you have changed any of the fields.
Delete: Select a user from the table at the bottom of the list and click to remove the user profile.
Clear: Click to erase all fields and enter new information.
IP Filters
The IP filter function enables you to define a minimum and maximum IP address range filter;
all IP addresses falling within the range are not allowed Internet access. The IP filter profiles
are listed in the table at the bottom of the page. (Note: Click anywhere in the item. Once the
line is selected, the fields automatically load the item's parameters, which you can edit.)
Figure 52.
Enable: Click to enable or disable the IP address filter function.
Range Start: Type the minimum address for the IP range. IP addresses falling between this
value and the Range End are not allowed to access the Internet.
Range End: Type the minimum address for the IP range. IP addresses falling between this
value and the Range Start are not allowed to access the Internet.
Add: Click to add the IP range to the table at the bottom of the screen.
Update: Click to update information for the range if you have selected a list item and have
made changes.
Delete: Select a list item and click Delete to remove the item from the list.
Clear: Click to erase all fields and enter new information.
36
To Next Page
Loading...
Need help?
Transmission and Reception
