Diagnostics and troubleshooting Deltabar PMD78B PROFINET with Ethernet-APL
68 Endress+Hauser
Diagnostic event and event text
The fault can be identified by means of the diagnostic event. The event text helps you by
providing information about the fault. In addition, the corresponding status symbol is
displayed in front of the diagnostic event.
X X X X X X XX X
S801
4
53
6
1
S
2X X X X X X XX X
A0038013
1 Status signal
2 Event text
3 Status symbol
4 Diagnostic event
5 Status signal
6 Event number
If two or more diagnostic events occur simultaneously, only the diagnostic message with
the highest priority is shown.
"Active diagnostics" parameter
Key
Opens the message about the remedial measures.
Key
Acknowledge warnings.
Key
Back to operating menu.
11.4 Diagnostic information in the Web browser
11.4.1 Diagnostic options
Any faults detected by the device are displayed in the header of the Web browser once the
user has logged on.
In addition, diagnostic events that have occurred can be displayed in the Diagnostics
menu.
Status signals
The status signals provide information on the state and reliability of the device by
categorizing the cause of the diagnostic information (diagnostic event).
Symbol Meaning
Failure
A device error has occurred
Measured value is no longer valid
Function check
Device is in the service mode (e.g. during a simulation)
To Next Page
Loading...
Need help?
General
