Deltapilot S FMB70 Repair and error handling
Endress+Hauser 31
Only original Endress+Hauser spare parts may be used here.
The repair must be documented. This includes:
• Serial number of the device
• Date of the repair
• Type of repair
• Person who performed the repair
Components may be repaired/replaced by the customer's specialist staff if original Endress
+Hauser spare parts (which can be ordered by the end customer) are used, and if the
relevant installation instructions are followed.
A proof test must always be performed after every repair.
Installation Instructions are supplied with the original spare part and can also be
accessed in the Download Area at www.endress.com
Send in replaced components to Endress+Hauser for fault analysis.
When returning the defective component, always enclose the "Declaration of
Hazardous Material and Decontamination" with the note "Used as SIL device in a
safety instrumented system.
Information on returns: http://www.endress.com/support/return-material
7.3 Modification
• Modifications to SIL devices by the user are not permitted as they can impair the
functional safety of the device
• Modifications to SIL devices on site at the user's plant are possible following approval by
the Endress+Hauser manufacturing center
• Modifications to SIL devices must be performed by staff who have been authorized to
perform this work by Endress+Hauser
• Only original spare parts from Endress+Hauser must be used for modifications
• All modifications must be documented in the Endress+Hauser W@M Device Viewer
• All modifications require a modification nameplate or the replacement of the original
nameplate.
7.4 Decommissioning
When decommissioning, the requirements according to IEC 61508-1:2010 section 7.17
must be observed.
7.5 Disposal
If required by the Directive 2012/19/EU on waste electrical and electronic equipment
(WEEE), the product is marked with the depicted symbol in order to minimize the
disposal of WEEE as unsorted municipal waste. Do not dispose of products bearing this
marking as unsorted municipal waste. Instead, return them to Endress+Hauser for
disposal under the applicable conditions.
To Next Page
Loading...
