Endress+Hauser Deltapilot S FMB70 - Order Codes; Identification Marking; Safety Function

Design Deltapilot S FMB70
8 Endress+Hauser
A modification process according to IEC 61508 is applied for any device modifications.
Any exemptions from possible combinations of features are saved in the Endress
+Hauser ordering system.
Valid device versions for safety-related use:
3.1.1 Order codes
Deltapilot S FMB70
Feature: 010 "Approval"
Version: all
Feature: 020 "Output; Operation"
Version:
• A: 4-20mA HART; extern. + LCD
• B: 4-20mA HART; inside + LCD
• C: 4-20mA HART; inside
• D: 4-20mA HART; Li=0 extern. + LCD
• E: 4-20mA HART; Li=0 inside + LCD
• F: 4-20mA HART; Li=0 inside
Feature: 030 "Housing; Cover sealing; Cable entry"
Version: all
Feature: 040 "Sensor range; Sensor overload limit"
Version: all
Feature: 050 "Calibration; Unit"
Version: all
Feature: 060 "Membrane material; Seal"
Version: all
Feature: 070 "Process connection"
Version: all
Feature: 090 "Fill fluid"
Version: all
Feature: 100 "Additional option 1"
Version: E; SIL
Feature: 110 "Additional option 2"
Version: E; SIL
Valid firmware version: from 02.00.zz (→ nameplate of the device)
Valid hardware version (electronics): from 02.00.ww (→ device nameplate)
3.2 Identification marking
SIL-certified devices are marked with the SIL logo on the nameplate.
3.3 Safety function
The device's safety functions are:
• Minimum, maximum or range monitoring
• Gauge pressure measurement
The assessment of the functional safety of a device includes the basic unit with the
main electronics, sensor electronics and sensor up to the sensor diaphragm and the
process connection mounted directly on the device. The process adapter and
mounted/enclosed accessories were not taken into account in the rating.