EasyManua.ls Logo

Endress+Hauser iTEMP TMT142B - Wizards; Commissioning wizard

Endress+Hauser iTEMP TMT142B
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
iTEMP TMT142B Commissioning
Endress+Hauser 35
8.3.2 Wizards
The starting point for device wizards is in the Guidance menu. Wizards not only query
individual parameters but also guide the user through the configuration and/or
verification of entire sets of parameters with step-by-step instructions, including
questions, that are comprehensible for the user. The "Start" button can be disabled for
wizards that require specific access authorization (lock symbol appears on the screen).
The following five operating elements are supported for navigation in the wizards:
Start
Only on the initial page: start the wizard and go to the first section
Next
Go to the next page of the wizard. Is not enabled until parameters are entered or
confirmed.
Back
Return to the previous page
Cancel
If Cancel is selected, the status before the wizard was started is restored
Finish
Closes the wizard and possibility of making additional parameter settings on the device.
Only enabled on the final page.
8.3.3 Commissioning wizard
Commissioning is the first step required in order to use a device for a specific application.
The Commissioning wizard contains an introductory page (with the "Start" operating
element) and a short description of the content. The wizard consists of several sections in
which the user is guided step-by-step through the commissioning of the device.
"Device management" is the first section that appears when the user runs the wizard, and
contains the following parameters. Its main purpose is to provide information about the
device:
Navigation Guidance → Commissioning → Start
+
+
-
A0053293
Device TAG
Device name
Serial number
Extended order code (n)
1)
1) n = placeholder for 1, 2, 3
The second section, "Sensor", takes the user through all the relevant settings for the sensor.
The number of parameters displayed depends on the corresponding settings. The following
parameters can be configured:
Navigation Guidance → Commissioning → Sensor
+
+
-
A0053294
Unit
Sensor type
Connection type
2-wire compensation

Table of Contents

Related product manuals