Endress+Hauser iTEMP TMT71 - Page 32

DRAFT
DRAFT DRAFT DRAFT DRAFT DRAFT DRAFT
DRAFT DRAFT DRAFT
Commissioning iTEMP TMT71/72
The following five operating elements are supported for navigation in the wizards:
• Start
Only on the initial page: start the wizard and go to the first section
• Next
Go to the next page of the wizard. Is not enabled until parameters are entered or
confirmed.
• Back
Return to the previous page
• Cancel
If Cancel is selected, the status before the wizard was started is restored
• Finish
Closes the wizard and possibility of making additional parameter settings on the device.
Only enabled on the final page.
8.3.1 Commissioning wizard
Commissioning is the first step towards using the device for the designated application.
The Commissioning wizard contains an introductory page (with the "Start" operating
element) and a short description of the content. The wizard consists of several sections in
which the user is guided step-by-step through the commissioning of the device.
"Device management" is the first section that appears when the user runs the wizard, and
contains the following parameters. Its main purpose is to provide information about the
device:
Navigation Guidance→ Commissioning → Start
+
-
+
A0037378-EN
Device TAG
Device name
Serial number
Extended order code (n)
1)
HART short tag
HART date code
HART descriptor
HART message
1) n = placeholder for 1, 2, 3
The second section, "Sensor", takes the user through all the relevant settings for the sensor.
The number of parameters displayed depends on the corresponding settings. The following
parameters can be configured:
Navigation Guidance → Commissioning → Sensor
+
-
+
A0037389-EN
Unit
Sensor type
Connection type
2-wire compensation
Reference junction
RJ preset value
32 V. 1, Rev. 2, 4-10-2018 Endress+Hauser