Endress+Hauser iTEMP TMT71 - Page 73

DRAFT
DRAFT DRAFT DRAFT DRAFT DRAFT DRAFT
DRAFT DRAFT DRAFT
iTEMP TMT71/72 Operating menu and parameter description
Navigation Application → Measured values → SV
Description Displays the secondary HART value
TV
Navigation Application → Measured values → TV
Description Displays the tertiary HART value
QV
Navigation Application → Measured values → QV
Description Displays the quaternary HART value
14.2.2 Submenu: Sensor
Unit
Navigation Application → Sensor → Unit
Description Use this function to select the engineering unit for all the measured values.
Selection • °C
• °F
• K
• Ω
• mV
Factory setting °C
Additional information Please note: if another unit has been selected instead of the factory setting (°C), all
the set temperature values are converted to correspond to the configured
temperature unit.
Example: 150 °C is set as the upper range value. Following the selection of °F as the
engineering unit, the new (converted) upper range value = 302 °F.
Sensor type
Navigation Application → Sensor → Sensor type
Endress+Hauser V. 1, Rev. 2, 4-10-2018 73