Endress+Hauser iTEMP TMT84 - Page 63

TMT84 11 Operation using PROFIBUS
®
PA
Endress + Hauser 63
11.2.3 Group Diagnostics
All the information that describes the device, the device status and the process conditions can be
found in this group.
The individual parameters are summarized in the Diagnostics menu:
Diagnostics menu
Submenu Diagnostics - System information

System information Page 63
 Diagnostics Page 63 Measured value 
Page 64
Min./max. values
Device test/reset Page 66
System information Standard Setup/Expert Basic settings that are needed to operate
the device.
Measured values

Min./max values
Standard Setup/Expert Settings for the measuring input of chan-
nel 1 and channel 2.
Device test/reset Standard Setup/Expert Settings for special diagnostics functions
such as drift or corrosion detection.
Diagnostics
Menu item Parameter
"Diagnostics"
(Expert
 Diag-
nostics)
Name
Parame-
ter access
Description
Current diagnostics read Displays the diagnostics code. The diagnostics code con-
sists of the "Current status" and "Current error code".
Example: F041 (Failure + sensor failure)
Current diagnostics
description
read Displays the status information as description text, see
chapter 9.3.
Status channel read Displays where in the device the highest priority error
occurs.
0: Device
1: Sensor 1
2: Sensor 2
Status count read The number of status messages currently pending in the
device.
Device bus adress read Displays the device bus address.
Factory settings:
126
System information
Menu item Parameter
"Diagnostics"
Submenu "System
information"
Name
Parame-
ter access
Description
Software Revision read Revision status of device firmware.
Device serial Num read
1
Displays the serial number of the device.
Order code read
1
Displays the device order code.
Order identifier read
1
Displays the order identification numbers as description
for the device delivery status.