Endress+Hauser Micropilot FMR56 - Page 58

Micropilot FMR56, FMR57
58 Endress+Hauser
FMR57 with horn antenna - standard version
R
A C
B
D
øD
øD
øD
ød
L
L
L2
112(4.41)
8(0.31)
23(0.31)
ød
L2
b
43 (1.69)
ø40 (1.57)
ø40 (1.57)
112(4.41)
A0023392
 36 Dimensions of FMR57 with horn antenna - standard version. Unit of measurement mm (in)
A Process connection: alignment unit with UNI flange
B Process connection: UNI flange
C Process connection: flange
D Process connection: thread MNPT1-1/2 or R1-1/2
R Reference point of measurement
ØD As per flange standard ASME B16.5 / EN1092-1 / JIS B2220
b As per flange standard ASME B16.5 / EN1092-1 / JIS B2220
Applies to the following device versions
• Feature 070 "Antenna"
• BC: horn 80mm/3"
• BD: horn 100mm/4"
• Feature 090 "Seal"
A6: Viton GLT, -40 to 200°C/-40 to 392°F
Dimensions of the antenna
Antenna Horn 80mm/3" Horn 100mm/4"
L 211 mm (8.37 in) 430 mm (16.9 in)
Ød 75 mm (2.95 in) 95 mm (3.74 in)
L2 50 mm (1.97 in) 50 mm (1.97 in)
For version with 250 mm (10 in) antenna extension (accessory):
300 mm (11.8 in) 300 mm (11.8 in)
For version with 450 mm (18 in) antenna extension (accessory):
500 mm (19.7 in) 500 mm (19.7 in)